Millipore Milli-Q Plus User Manual download pdf (Page 16)

- 16 -

Specifications and requirements

Milli-Q

Water

quality

The water delivered from a POD Unit has the following characteristics.

Parameter Specification Units

Resistivity 18.2

M.cm @25°C

TOC

 5

ppb

Particulates > 0.22 m**

< 1 Particulates/mL

Bacteria** < 0.1 cfu/mL

Pyrogens* < 0.001 Eu/mL

RNases* < 0.01 ng/mL

DNases* < 4

pg/L

Flow Rate** 0.05 – 2 L/min

(*) With BioPak



Final Filter

(**) With Millipak



or BioPak Final Filter

NOTE:

These specifications are valid for Elix water feed within specification and for

routine operation. Some specifications may not be achieved at start-up.

Weight

The various weights are found in the table below.

Item Operating

Weight

Dry Weight Shipping

Weight

Milli-Q Reference

System

19.5 kg 14.5 kg 19 kg

Electrical

The electrical specifications and data are found in the table below.

Parameter Value

Voltage

100-230 VAC 10%

Frequency

50-60 Hz 10%

Main Fuse 3.15 Amp Fast Acting; 5 mm x 20 mm; 250 V safety

voltage.

The fuse should be serviced by a qualified Millipore

Service Representative.

Power Used 125 VA

Power Cord Length 2.5 metres

Electrical Ground Earth Grounded

Power Cord use The System is powered on and off by removing the

power cord from the wall outlet.

The power cord should be plugged into a wall outlet

that is accessible.

Continued on next page

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 89 90

Comments to this Manuals

No comments

Millipore Milli-Q Plus User Manual Page 16

Comments to this Manuals