Millipore Milli-Q Plus User Manual Page 87

  • Download
  • Add to my manuals
  • Print
  • Page
    / 90
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 86
- 87 -
Summary of Alert messages
Alert messages
LCD message What it means
CALIBRATION VISIT
OVERDUE XX DAYS
The System has determined that a
Calibration Visit is overdue.
Contact Millipore.
CHECK UV 185 NM LAMP The UV 185 nm Lamp is not turning on.
Contact Millipore.
EXAMINE INLET STRAINER The System has determined that it is
time to clean the Inlet Strainer.
Clean the Inlet Strainer and reset the
message.
MILLI-Q FEED
CONDUCTIVITY > SP
The measured feedwater conductivity is
> Set Point.
Check the source of feedwater and its
conductivity.
MILLI-Q INTERMEDIATE
RESISTIVITY <SP, PLEASE
ORDER Q-GARD AND
QUANTUM
The measured resistivity after the
Q-Gard Pack is < Set Point.
The Q-Gard Pack and Quantum
Cartridge are replaced together. Contact
Millipore about ordering a replacement
Q-Gard Pack and Quantum Cartridge.
NEXT CALIBRATION VISIT
IN XX DAYS
The System is prompting you that a
Calibration Visit should be scheduled.
Contact Millipore.
NEXT QUALIFICATION
VISIT IN XX DAYS
The System is prompting you that a
Qualification Visit should be scheduled.
Contact Millipore.
NEXT SERVICE VISIT IN XX
DAYS
The System is prompting you that a
Service Visit should be scheduled.
Contact Millipore.
NO RESPONSE FROM DHCP
SERVER
Contact your network administrator.
Restart the System.
QUALIFICATION VISIT
OVERDUE XX DAYS
The System has determined that a
Qualification Visit is overdue.
Contact Millipore.
REPLACE POD PAK The System has determined that the
POD PAK needs replacement.
Replace the POD Pak and reset the
timer.
REPLACE POD PAK IN XX
DAYS
The System has determined that the
POD PAK should be replaced in XX
days, where XX is 15, …, 1.
Replace the POD Pak and reset the
timer.
Continued on next page
Page view 86
1 2 ... 82 83 84 85 86 87 88 89 90

Comments to this Manuals

No comments